Hi
Have a couple of LS6840's and having an issue with one of them. Some very simple designs will "TEST" OK, but when cutting we're sometimes getting a "LIMIT STOP" when the head reaches the back edge of the bed. This seems to be related to certain designs only and only occurs on the one machine.
Any thoughts?
(It's entirely possible that machine and/or software settings have been fiddled with - will double check these in a minute)
Thanks all.
LS6840 Limit stop
Re: LS6840 Limit stop
Possibly software setting - are the machines the same age? I had this on a newer 3060 when I used the wrong config file from the older software disk.
Cheers
Dave
Cheers
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 2 guests