Hi from a 6090 used user

Moderators: HPC, Daven

Post Reply
markgreenhalgh
Posts: 1
Joined: Sat Oct 31, 2020 10:47 am
Contact:

Hi from a 6090 used user

Post by markgreenhalgh »

Just bought off ebay a used 6090 which needs a full overhaul which hopefully we can do.

A couple of early questions - what is the fuse size in the rear fuse holder please and is it possible to get a demo copy of Lasercut 5.3 without having to buy the dongle just so we can make sure that everything works
Daven
Posts: 1632
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Hi from a 6090 used user

Post by Daven »

Hi - I can't help with first question, drop HPC an email ;)

There used to be a demo version on Letros website but it would not let you test the machine. You may also need the cfg settings and the drivers to use the machine.

You can test to see if the laser fires from the control panel if it does you can then see if there are any files left in memory, failing that have a word with HPC and see if they can email a simple file that you can load onto the machine via the usb memory stick port.

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Post Reply

Who is online

Users browsing this forum: No registered users and 13 guests