Hello all. LS 3020 user. Mainly for fun.
Posted: Sat Mar 11, 2017 10:10 pm
Hello all.
I've had my 3020 since 2013. Used lightly for prototyping and enjoyed the simplicity of it.
However. During a full power job on Friday, it made an odd pop sound (which sounded a bit like when foam catches fire momentarily) so I didn't worry. The job continued and seemed to be fine.
Then I turned the power right down to do some light engraving. The job was destroyed. The laser seemed to be stuck at mid to high power. The control knob has no effect.
Any ideas? Happy to replace any parts.
Thanks in advance.
I've had my 3020 since 2013. Used lightly for prototyping and enjoyed the simplicity of it.
However. During a full power job on Friday, it made an odd pop sound (which sounded a bit like when foam catches fire momentarily) so I didn't worry. The job continued and seemed to be fine.
Then I turned the power right down to do some light engraving. The job was destroyed. The laser seemed to be stuck at mid to high power. The control knob has no effect.
Any ideas? Happy to replace any parts.
Thanks in advance.