Hi Everyone

Moderators: HPC, Daven

Post Reply
gsace
Posts: 8
Joined: Wed Oct 19, 2016 2:18 pm
Contact:

Hi Everyone

Post by gsace » Thu Oct 27, 2016 1:47 pm

Just bought a HPC 3020. Huge learning curve to go through so that I can use it. I've only used a Craft Robo/Silhoutte Cameo before so big difference. Looking forward to reading the forum to get some hints and tips on how best to use the machine.

Daven
Posts: 1356
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Hi Everyone

Post by Daven » Thu Oct 27, 2016 1:57 pm

Hi - welcome ;)
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

Lightnin
Posts: 153
Joined: Wed Feb 25, 2015 2:50 pm
Contact:

Re: Hi Everyone

Post by Lightnin » Fri Oct 28, 2016 8:42 am

Howdy :-)

if you've used the Cameo and similar you are more than half way there.
You'll have to learn the laser power and speed etc. but the software/design/layout will be similar.
Maybe even the same depending on how you usually design.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest