Moderators: HPC, Daven

Post Reply
Posts: 1
Joined: Thu Sep 17, 2015 5:14 pm


Post by jacs555 » Sat Sep 10, 2016 8:18 pm

Hi, I'm new to the forum... Hi everyone!! :D
Everything is sweet with the laser machine until something goes wrong! The mentality of 'if it doesn't work, hit it' is so close!! Been using my machine 12 months and have had few problems and can pretty much sort them. however.... I'm trying to engrave a plaque and it's engraving a mm out and sloping. The only way I've previously aligned them is by the top line of the tray. (not sure this is even correct, but never had a problem ). There's a bit of movement on the tray but tried it a few times and its still not straight. I'm a woman. technical isn't really my thing and I could really do with a bit of guidance.... before I turn to alcohol!! Many thanks

Posts: 1576
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon

Re: engraving

Post by Daven » Sun Sep 11, 2016 10:17 am

What machine?

If the image is being engraved out of true (the sides are sloped rather than square) it could be the belts/head - have you cleaned the runner and lubricated recently?

Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests