Hi from the Sunny West Midlands

Moderators: HPC, Daven

Post Reply
Proby
Posts: 3
Joined: Sun Apr 04, 2021 2:48 pm
Contact:

Hi from the Sunny West Midlands

Post by Proby » Sun Apr 04, 2021 4:19 pm

Hi all,

Hope you are all having a great Easter Bank Holiday weekend.

Joined after recently acquiring a second hand HPC LS3040 that is a few years old but looks like it has had no use.

New to laser cutters but run a collection of equipment from eco solvent wide format to small UV flatbed. Also have a vinyl plotter and a 3D printer so pretty good with technology.

I'm after some help but I'll start a new post in the appropriate place on the forum.

Regards,

Chris
HPC LS3040 (old desktop version)
Lasercut 5.3

Daven
Posts: 1617
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Hi from the Sunny West Midlands

Post by Daven » Sun Apr 04, 2021 5:39 pm

Hi Chris - welcome ;)
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests