Newbie here!

Moderators: Daven, HPC

Post Reply
Rog
Posts: 3
Joined: Sun Jan 14, 2018 11:33 pm
Contact:

Newbie here!

Post by Rog » Fri Jan 19, 2018 2:26 pm

Hi everyone,
just thought I'd say hello.
Just got my 1290 and starting to get to grips with cutting.

Doing ok so far but still got loads to learn!

Probably see some of you in the help forums :lol:

Cheers!

Daven
Posts: 1342
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Newbie here!

Post by Daven » Fri Jan 19, 2018 3:30 pm

Hi Rog, welcome ;)

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest