Page 1 of 1

Card cutting

Posted: Mon Dec 17, 2018 7:01 pm
by ooper
Do anyboy here cut card , i got a wedding coming up in the family and got to cut card / paper ect any info will be great thanks

Re: Card cutting

Posted: Sun Apr 14, 2019 5:50 pm
by Littlebirdsengraving
Hi ooper,

I sell cards through Etsy that are both engraved and cut. I just use Kraft card in A6.

I have a LS3040 with a 60 Watt Tube.

Settings I use are:

Engraving - 500% Speed, 20% Power

Cutting - 10% Speed, 15% Power.

Hope this helps!

Re: Card cutting

Posted: Fri Oct 04, 2019 12:15 pm
by ooper
Thanks bud , could you tell me the settings you use for cutting 3 mm ply please

Re: Card cutting

Posted: Fri Nov 01, 2019 9:46 pm
by Dynamode
Give Manila a try, Soft Card is a bit hit and miss when you Cut it and gives off a lot of Soot. Manila is a harder type of Finish and Cuts really well.

You'll get some good results using it.

Dynamode.