Hello,
Can anyone tell me if you can Laser Etch Quartz, I have some off cuts of Worktop.
Has anyone tried it and what sort of results did you get.
Thanks for and advice.
Dynamode.
Quartz Worktop
Re: Quartz Worktop
As far as I know you can but it may take slow speed and high power especially if it is light in colour. All I have done is slate!
Obviously be careful with any dust - doubt it will do you any good or the machine!
Best
Dave
Obviously be careful with any dust - doubt it will do you any good or the machine!
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 4 guests