Help

Moderators: Daven, HPC

Post Reply
Traceym
Posts: 12
Joined: Sun Mar 19, 2017 5:55 pm
Contact:

Help

Post by Traceym » Fri Apr 14, 2017 6:23 pm

Help my new favourite word since my my laser arrived on Wednesday lol
Today's drama laser starts to engrave a few lines then it cuts on to cut mode what am I missing any hints would be good . Thanks tx

Daven
Posts: 1342
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Help

Post by Daven » Sat Apr 15, 2017 7:27 pm

What are you trying to engrave?

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest