Mirror Alignment 3040

Moderators: HPC, Daven

Post Reply
ooper
Posts: 16
Joined: Wed Nov 28, 2018 10:15 am
Contact:

Mirror Alignment 3040

Post by ooper » Sat Oct 05, 2019 7:39 pm

Hi I’m still getting a little confused on which way to adjusted the thumbscrews on the back of the mirrors and what screw mover the mirror left / right / up /down , have anyone got a diagram / drawing that I can print out please

Daven
Posts: 1463
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Mirror Alignment 3040

Post by Daven » Sun Oct 06, 2019 7:28 pm

There are various videos on Youtube that may help.

As a rough guide, screwing in the bolt moves the beam away from the screw - so say the screw was bottom left, 7 o'clock it would move the beam towards 2 o'clock. Turn the screw in small amounts - I imagine it as a clock face so turn the screw say 10 seconds clockwise - if that is wrong I can turn it back 10 seconds and start again :)

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

ooper
Posts: 16
Joined: Wed Nov 28, 2018 10:15 am
Contact:

Re: Mirror Alignment 3040

Post by ooper » Mon Oct 07, 2019 5:25 pm

Thank you

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests