Antler

Moderators: Daven, HPC

Post Reply
Dynamode
Posts: 18
Joined: Wed Jan 22, 2014 8:04 am
Contact:

Antler

Post by Dynamode » Tue Jun 19, 2018 7:31 am

Hello, Is there anyone who has tried to Laser Etch Antler. I have seen that it can be done, but is it safe to do this and is the Filter System on the 1290 enough to take away the waste or would you need a better system.

Thanks for any Help. Dynamode

Daven
Posts: 1342
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Antler

Post by Daven » Tue Jun 19, 2018 8:00 am

As a guess I would think it was ok but may smell, start with low power.

It may be like Rhino horn though but the effects should ware off after a short while :lol:

Cheers
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

rylosdesign
Posts: 2
Joined: Tue Jun 28, 2016 11:38 am
Contact:

Re: Antler

Post by rylosdesign » Tue Nov 06, 2018 12:52 pm

I did one years ago, no problem at all. Hardest bit was jigging it so the laser could get to the focal point where the etch point was !!

Have no idea what settings I used, but from memory I just ran a few passes, starting at high-ish speed and low power until the etch was as dark as looked good.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest