Can resin be engraved?

Moderators: HPC, Daven

Post Reply
Posts: 74
Joined: Mon Feb 08, 2016 11:41 am

Can resin be engraved?

Post by sam » Wed Mar 07, 2018 7:54 pm


Having a bit of an issue finding out anything about this. Does anyone know if polyurethane casting resin (once poured and cast) can be laser engraved?.

I guess it's more of a case of it giving off potentially nasty gases, as the engraving itself would technically work.



Posts: 1414
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon

Re: Can resin be engraved?

Post by Daven » Wed Mar 07, 2018 9:02 pm

"Dust from sanding and cutting finished polyurethane may cause skin and respiratory problems due to the presence of unreacted chemicals from the curing process."
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest