Set a constant zero point?
Posted: Mon Sep 25, 2017 11:47 am
Hey fellow cutters!
I want to set a zero point on my LS6040 - a place where I can send the laser to for the start of particular cuts - is that possible?
For greater detail, I'm hoping to etch and cut double-sided tokens (about 10-20mm) on a production scale, so I need to be able to quickly place and start cuts. In order to do so, I want to set up a jig to make sure that what I'm cutting goes in exactly the same place, and also so that I can thoroughly clean the cutting bed between each run so as not to damage any of the engraved layers.
Any advice at all on this would be greatly appreciated!
I want to set a zero point on my LS6040 - a place where I can send the laser to for the start of particular cuts - is that possible?
For greater detail, I'm hoping to etch and cut double-sided tokens (about 10-20mm) on a production scale, so I need to be able to quickly place and start cuts. In order to do so, I want to set up a jig to make sure that what I'm cutting goes in exactly the same place, and also so that I can thoroughly clean the cutting bed between each run so as not to damage any of the engraved layers.
Any advice at all on this would be greatly appreciated!