Laserscript user forum

Thanks Dave,

It turned up yesterday, a little bigger than I was expecting, most likely because of how much larger than what it is replacing!

I will do a bit of e-bay shopping then

Thanks for the advice

Regards

Mark

Hi, I have seen in some posts within the forum that upgrading the air assist compressor helps cutting etc. The Titan 21l appears to be the most recommended replacement and is quite reasonable cost wise. My question is what about the pipe from the compressor to the port at the back of the laser (3060...

Hi all,

I have just brought a new 3060 and am just getting to grips with it, a few mistakes along the way but isn't that the best way to learn? Am looking forward to learning more and will no doubt be posting again soon for some help when I can't figure something out