Laserscript user forum

Hi Paul,

I am upgrading my 6840 to a Ruida controller and have a bit of a problem the the connections.

How did you get on with the wireing and who did you get the diagram from or was the work carried out by HPC ?

Thanks Bob

Many thanks Dave, that was the problem although I’m not sure how it changed.

Regards

Bob

Hi all, As usual I have a rush job over the weekend....then I have a probem. I am working on a job that has engraving and low power cutting, I had no problem with this before, the engraving is fine but the laser has stopped firing when cutting, also when you press the Laser test button nothing happe...

afaik Bob there is no direct output to the LS series, I think you need to save the pic as a BMP and import from there. I haven't used PG for some time though so things may have changed. best wishes Dave Thanks Dave, It wasn't so much the output to the laser, more on the actual laser setting in Phot...

avalonman wrote:are you using my rotary program or just trying to enter the data into the laserscript program

PM sent

I have just got my copy of Photograv, in the machine selection there is no mention of the Laserscript, does anyone
Know what the nearest machine to a LS 6840
or what setting I need.

Many thanks

Bob.

Joe,

Try here. http://ncplot.com/stickfont/stickfont.htm


Bob

Problem solved......I decided to start again with fresh de-ionised water without the Milton, I flushed through the system with the existing water adding a squirt or Fairy liquid....all the bubbles vanished, the tube is so clear it looks like it has no water at all. I checked with HPC regarding the F...

avalonman wrote:I had a bubble problem that sounds the same.

I solved mine by lifting the machine about 2 degrees on the side where the water exits the tube, it might help

Thank you, but I have done that.

PhillyDee wrote:I would flush it through, and use pure deionised, just in case its the milton.

The exit part of the tube is flow restrictive.

I will give it a try